Speedo sensor with 100cm lead and 3 pin plug for non-ABS models

 This part is due back in stock soon, call 01484 841395 to reserve yours

AP8124528

Also fits Aprilia Falco (2000-2003)

3 position 4 pin ignition switch includes start position

Male spade connectors to rear, supplied with 2 keys

 This part is available by special order, request a quote

 12735300 GU12735300 12 73 53 00
 1273 5300 1273.5300 12.73.53.00

Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Complete round 203mm left hand dip (UK spec) headlight unit with bulb. Black body with chrome rim.

Due to the scarcity of LH dip Italian made headlights we have sourced this reasonably priced alternative which is similar in size to the headlamp used on V50 and T3 models. Supplied complete with headlight bulb. Headlamp is slightly larger than stock so some repositioning of the headlamp brackets may be required. Please note there is no pilot light with this headlamp and thread size for bolt fixing holes is M8. This is a smaller thread than the M10 thread on T3 indicator stems.

 This part is available by special order, request a quote

Black spark plug cap, this does not include the 90 degree bend or HT lead but is significantly cheaper than the genuine part

For models with 4 valves per cylinder, with the very easily damaged internal plug caps.
Also known as suppressor cap.
NOT for models with 2 valves per cylinder. See ELA18134 for HT leads, although these come with different plug caps.

 This part is due back in stock soon, call 01484 841395 to reserve yours

 883028 MG883028

Support for oil temperature sensor

 This part is available by special order, request a quote

 03163330 GU03163330 03 16 33 30
 0316 3330 0316.3330 03.16.33.30

Complete round black headlight with chrome rim, complete with bulb and pilot light. Right hand dip non-UK spec.

This light will fit Le Mans Fairing FAA99575

 This part is available by special order, request a quote

Brakelight switch for handlebar mounted master cylinder

Stop light switch also known as Guzzi ref. 30530526. Please compare with your existing switch to check compatibility. Can be used as a substitute for ELA27815 or ELA30860. Sometimes supplied with three terminals, in this instance disregard middle terminal. Please note that terminals are smaller than standard switch and will need to be soldered on.

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30749860 GU30749860 30 74 98 60
 3074 9860 3074.9860 30.74.98.60

Sidestand cutout switch

See ELA81319 for rotary switch that was fitted to some models

 This part is available by special order, request a quote

 639542 MG639542

Oil pressure switch

Does not fit models with 2 valves per cylinder. See ENA12640 for replacement crush washer if required.

Discontinued by Guzzi in 2014, superceded by ELA32710, note ELA32710 has a single male spade connector so it will be necessary to modify wiring to connect this switch

 Sorry, this part is no longer available.

 978854 MG978854